#Ecu flash zx10r install
If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply). You can purchase this as a package on the product page for your bike. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. Woolich Racing Race Tools requires you to Write the ECU. ** The Pit Speed Limiter and Engine Warm Up requires the purchase of an additional Pit Speed Limiter Harness. * Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length. Launch Control allows you to configure Delay, Launch RPM and Hold Speed.Įngine Warm up parameters are fully configurable. Pit Speed Limiter RPM can be configured.**
#Ecu flash zx10r full
Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.Īutoblipper Opening and Target maps are fully configurable per gear. Race Tools Key to allow the use of the Race Tools on one ECU in the Woolich Racing Tuned software.Kawasaki Race Tools Type 5 which allows the quickshifter to be plugged into the bikes wiring harness**.Shift rod for standard shift configuration*.High quality dual direction strain gauge Quickshifter with digitally controlled pressure sensing that can be used in regular or race shift pattern.
The Race Tools package allows you to add Autoblipper, Quickshifter, Pit Speed Limiter, Engine Warm Up and Launch Control to the Stock ECU. Race Tools: Quickshifter, Launch Control, Pit Speed Limiter This package includes everything you need to start tuning your 2008-2010 Kawasaki ZX10R with our USB (Mitsubishi) and On Bike Harness. This package includes everything you need to start tuning your 2006-2007 Kawasaki ZX10R with our USB (Mitsubishi) and on bike harness allowing you to flash the ECU while it is still in the bike connected to the bike harness. Additional Bin File Definition Keys are required for each additional ECU's and can be purchased from within the WRT software. This product comes with 1 Bin File Definition Key allowing you to tune 1 ECU's as many times as you like.